[. . . ] When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. This 'bolt of lightning' indicates uninsulated material within your unit may cause an electrical shock. For the safety of everyone in your household, please do not remove product covering. [. . . ] When you see the crossed-out wheel bin symbol attached to a product, it means the product is covered by the European Directive 2002/96/EC: EN 5 Eng lish 2 Your Android docking speaker Congratulations on your purchase, and ZHOFRPH WR 3KLOLSV 7R IXOO\ EHQHÀW IURP WKH support that Philips offers, register your product at www. philips. com/welcome. Overview of the main unit a b Introduction With this unit, you can enjoy audio from the Android phone. d What's in the box Check and identify the contents of your package: Main unit Power adapter Quick start guide e c a Dock for Android phone b Display panel Show time. Adjust time. 6 EN 3 Get started Always follow the instructions in this chapter in sequence. Eng lish Connect power Caution Risk of product damage!Ensure that the power voltage corresponds to the voltage printed on the back or underside of the device. When you unplug the power adapter, always pull the plug from the socket. Never pull the cord. Connect the power adapter to: the rear socket of the docking system. the wall socket. Adjust the brightness of night light 1 2 Press . » Bluetooth indication light on the display panel begins to blink. Press CLOCK/NIGHT LIGHT repeatedly to adjust the brightness of the night light at the bottom. » The brightness of the night light toggles between high level, normal level and off mode. Adjust the brightness of display panel 1 In standby mode, press CLOCK/NIGHT LIGHT repeatedly to adjust the brightness of display panel. » The brightness of the time digits on the display panel toggles between high, medium and low level. EN 7 Switch to standby mode Press again to switch the docking system to standby mode. » The Bluetooth indication light on the display panel goes off. Connect Bluetooth 1 2 Set clock 1 In standby mode, press and hold CLOCK/ NIGHT LIGHT for two seconds to activate clock setting mode. Press CLOCK/NIGHT LIGHT WR FRQÀUP » The hour digitbegins to blink. [. . . ] When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available. No power Ensure that the AC power adaptor of the unit is connected properly. [. . . ]